SkyTrak 6036 Service Manual - Manual (Page 145)

7-9 6036, 6042, 8042, 10042, 10054
Engine
10. Lift right side and slip bolts up and through slots on
the right side of frame.
11. Place mounting plate on level surface and replace
muffler, clamps and tailpipe. Note position of muffler
for re-installation purposes.
7.7.2 Exhaust System Installation - LS
Note: Install muffler in proper direction.
Note: Keep all clamps loosened until entire exhaust
system is in place.
1. Install muffler and tailpipe on muffler mounting
plate (12) using proper clamps in proper position.
2. Lift muffler mounting plate up and slide mounting
plate bolts (13) through slot in right side of frame.
3. Lift left side of muffler mounting plate up and
re-install mounting plate bolts (14).
4. Tighten all mounting plate bolts.
5. Install exhaust pipe (11) to muffler and engine.
6. Tighten all clamps (10).
7. Properly connect the battery.
8. Remove the Do Not Operate Tags from both the
ignition key switch and the steering wheel.
9. Start engine and check for exhaust leaks at all
exhaust connections. Adjust or repair as needed.
10. Close and secure the rear door.
7.7.3 Exhaust System Installation - ULS
Note: Install muffler in proper direction.
Note: Keep all clamps loosened until entire exhaust
system is in place.
1. Install muffler and tailpipe on muffler mounting
plate (12) using proper clamps in proper position.
2. Lift muffler mounting plate up and slide mounting
plate bolts (13) through slot in right side of frame.
3. Lift left side of muffler mounting plate up and
re-install mounting plate bolts (14).
4. Tighten all mounting plate bolts.
5. Verify dimension (A) 1.94-2.06 in (49,2-52,3 mm)
between the end of the muffler (15) and the inside of
the left frame rail (16).
6. Adjust the muffler intake tube to approximately (B)
22.0°.
7. Tighten band clamp (17) enough to hold the muffler
in place.
8. Install exhaust pipe (11) to muffler and engine.
Tighten each clamp to secure the exhaust pipe in
place.
9. Measure distance (C) 8.75-9.5 in (222,2-241,3 mm)
on the flex pipe section of the exhaust pipe (11).
MAQ1190
16
A
15
VIEW FROM REAR OF MACHINE
C
B
MAQ1170
11
17