SkyTrak 6036 Service Manual - Manual (Page 217)

9-29 6036, 6042, 8042, 10042, 10054
Electrical System
9.12.2 Dash Switches
a. Switch Removal
1. Park the machine on a firm, level surface, level the
machine, fully retract the boom, lower the boom,
place the transmission control lever in
(N) NEUTRAL, engage the park brake and shut the
engine OFF.
2. Place a Do Not Operate Tag on both the ignition key
switch and the steering wheel, stating that the
machine should not be operated.
3. Open the rear door. Allow the system fluids to cool.
4. Properly disconnect the battery.
5. Carefully pry the switch and wiring (7) out of the
mounting plate (8).
6. Label and disconnect the wiring from the switch.
Remove the switch.
b. Disassembly
DO NOT disassemble the dash switch. Replace a
defective switch with a new part.
c. Inspection and Replacement
Inspect the switch terminals for continuity and shorting in
both the engaged and disengaged positions. Replace a
defective or faulty switch with a new switch.
d. Switch Installation
1. Connect the switch to the cab harness connector.
2. Position the switch over the rectangular switch bezel
and snap into position.
3. Properly connect the battery.
4. Remove the Do Not Operate Tags from both the
ignition key switch and the steering wheel.
5. Start the machine and check the replaced switch for
proper function.
6. Close and secure the rear door.
MAQ0770
7
8