Use SHARP-recommended paper.
Using paper that is for other models or special paper
that is not supported may result in misfeeds, creases, or
smudges.

☞

"SUPPLIES" in the Start Guide

Are you printing on pre-punched paper?

Take care that the image does not overlap the
punch holes.
If the printed image overlaps the punch holes, smudges
may appear on the reverse side of the paper following
one-sided printing, or on both sides following two-sided
printing.

Does a message appear indicating the
need for maintenance?

Contact your dealer or nearest authorised service
representative as soon as possible.

Toner does not adhere
well or creases appear
in the paper.

Are you using paper that is not within
the specifications?

Use SHARP-recommended paper.
Using paper that is for other models or special paper
that is not supported may result in misfeeds, creases, or
smudges.

☞

"SUPPLIES" in the Start Guide

Did you set the correct paper type?

Set the correct paper type in the tray settings.
Make sure that the following has not occurred:

• Heavy paper is being used, but a paper type other

than heavy paper is selected in the tray settings. (The
image may disappear if rubbed.)

• Paper other than heavy paper is being used, but

heavy paper is selected in the tray settings. (This may
cause creases and misfeeds.)

➞ System Settings > "Paper Tray Settings" > "Tray

Settings"

Is the paper loaded so that printing
takes place on the reverse side?

Check that the paper is loaded so that printing takes
place on the correct side.
If printing takes place on the wrong side of label sheets
or transparency film, the toner may not adhere well and
a clear image may not be obtained.

Print quality is poor.

Is "Toner Save Mode" enabled?

Check with your administrator.
When "Toner Save Mode" is enabled, printing takes
place using less toner and thus the print result is lighter.

This manual is related to the following products:

MX-3114N