Toshiba Magnia 560S - Manual (Page 99)

Troubleshooting
Troubleshooting
81
BIOS Boot Error Messages
Table 7.2 lists the BIOS boot error messages, problems, and suggested solutions.
Table 7.2 BIOS Boot Error Messages
Message Problem Suggested Solution
Adapter BIOS Disabled.
No Logical Drives
Handled by BIOS The MegaRAID BIOS is
disabled. Sometimes the
BIOS is disabled to
prevent booting from the
BIOS. Enable the BIOS using the
MegaRAID BIOS
Configuration Utility.
Host Adapter at Baseport
xxxx Not Responding The BIOS cannot
communicate with the
adapter firmware. Make sure RAID
Controller Kit-G is
properly installed.
No RAID Controller Kit-
G Adapter The BIOS cannot
communicate with the
adapter firmware. Make sure RAID
Controller Kit-G is
properly installed.
Configuration of
NVRAM and drives
mismatch.
Run View/Add
Configuration option of
Configuration Utility.
Press any key to run the
Configuration Utility.
The configuration stored
in the RAID Controller
Kit-G adapter does not
match the configuration
stored in the drives. Press a key to run
MegaRAID Manager .
Choose View/Add
Configuration from the
Configure menu.
Use View/Add
Configuration to examine
both the configuration in
NVRAM and the
configuration stored on the
disk drives. Resolve the
problem by selecting one
of the configurations.
1 Logical Drive Failed A logical drive failed to
sign on. Make sure all physical
drives are properly
connected and are powered
on.
Run MegaRAID Manager
to find out if any physical
drives are not responding.
Reconnect, replace, or
rebuild any drive that is not
responding.