Initialize, Check consistency, Properties – Toshiba Magnia 560S User Manual
Page 149
Logical Drives
WebBIOS Configuration Utility
131
The upper right section of the screen displays the logical drives that currently exist.
Below that section are options to:
•
Initialize the logical drives
•
Check consistency
•
Display the logical drive properties
Press Go to perform the selected action or Reset to delete any changes.
Initialize
You should initialize each new logical drive that you configure. You can use the
Initialize option on the Logical Drives screen to initialize logical drives. Perform the
following steps to initialize a logical drive.
1. Select the Logical Drives option from the MegaRAID WebBIOS main screen.
2. On the Logical Drives screen, select the logical drive to be initialized.
3. Click in the box next to Initialize, then click on Go.
The progress of the initialization appears as a graph on the screen.
4. When initialization completes, click on the Back button to display the previous
menu.
Check Consistency
Select this option to verify the correctness of the redundancy data. This option is
available only if RAID level 1 or 5 is selected. MegaRAID automatically converts any
differences found in the data.
After you click on Check Consistency and the Go button, a progress chart displays on
the left side of the screen to show how much of the consistency check has been
completed. There is also an option to abort the check for any or all logical drives.
Properties
Select this option to:
•
Display the logical drive properties (such as RAID level, logical drive size, and
stripe size)
•
Display the read, write and I/O policies
•
Change the read, write and I/O policies
•
Start initialization
•
Start a consistency check