In this manuals, Megaraid bios configuration utility – Toshiba Magnia 560S User Manual
Page 108
In this Manual
90
Introduction
In this Manuals
This MegaRAID Controller Configuration Software Guide is organized as follows:
•
Chapter 8, Introduction
•
Chapter 9, MegaRAID BIOS Configuration Utility
•
Chapter 10, WebBIOS Configuration Utility
•
Chapter 11, Installing Power Console Plus
•
Chapter 12, Running Power Console Plus
•
Chapter 13, Configuring Arrays and Logical Drives with Power Console Plus
•
Chapter 14, Virtual Sizing and Online Capacity Expansion
•
Appendix A, MegaRAID Service Monitor
•
Appendix B, Audible Warnings
•
Appendix C, MegaRAID Service Monitor
NOTE: Some of the features and procedures in this manual apply only to
boards that support Ultra 320M, and 40 logical drives. This will be noted in
the description of the feature or procedure. The Ultra 320M boards are:
−
MegaRAID SCSI ZCR 320-0 (Series 520)
−
RAID Controller Kit-G (Series 520)
−
MegaRAID SCSI 320-2 (Series 518)
The following sections briefly describe the configuration software programs that are
documented in this manual.
MegaRAID BIOS Configuration Utility
The MegaRAID BIOS Configuration utility is a character-based utility than you can
run by pressing
Configuration Utility to:
•
Create hot spare drives
•
Configure physical arrays and logical drives
•
Initialize one or more logical drives
•
Individually access controllers, logical drives, and, physical drives
•
Low-level format hard disk drives
•
Rebuild failed disk drives
•
Verify that the redundancy data in logical drives using RAID level 1, or 5 is correct
•
Select a MegaRAID host adapter to work on