Toshiba Magnia 560S - Manual (Page 118)

Starting the MegaRAID BIOS Configuration Utility 100
MegaRAID BIOS Configuration Utility
Table 9.3 Adapter Menu Options (Continued)
Option Description
Factory Default Select this option to load the default MegaRAID
Configuration Utility settings.
Enable/Disable BIOS Select this options to enable or disable the
BIOS. If the boot device is on the RAID
controller, the BIOS must be enabled;
otherwise the BIOS should be disabled or it
might not be possible to use a boot device
elsewhere.Enabling the BIOS allows and
disabling the BIOS stops hooking of the
INTERRUPT 13H from the MegaRAID BIOS
level for logical drives found at the BIOS level
for the individual card.
Emulation Select this options to operate in Mass Storage or
I2O mode.
Auto Rebuild Set this option to Enabled to automatically
rebuild drives when they fail.
Initiator ID ID for the cluster card. It cannot have the same
ID as the other node. The default is 7.
Cluster Mode Use this option to enable or disable cluster mode.
When you disable cluster mode, the system
operates in standard mode.
Multiple PCI Delayed Trans
Force Boot Set to ON to have BIOS write the disk
configuration to the NVRAM in case of a
configuration mismatch.
Coercion Algorithm The options are None, 128MB-way, and 1GB-
way.