beautypg.com

Pci bridge/cpu – Toshiba Magnia 560S User Manual

Page 55

background image

Operating System Software Drivers

Features

37

Table 4.6 RAID Controller Kit-G Specifications (Continued)

Parameter

Specification

Cache configuration

Predefined during manufacturing; ECC through a
66MHz 72-bit unbuffered 3.3V SDRAM.

Firmware

1 MB × 8 flash ROM

Non-volatile random access
memory (NVRAM)

32 KB × 8 for storing RAID configuration

Operating voltage

5.00 V ± 0.25 V

SCSI controller

One SCSI controller for Ultra320 and Wide
support

SCSI data transfer rate

Up to 320 MB/s

SCSI bus

LVD or single-ended

SCSI termination

Active, single-ended or LVD

Termination disable

Automatic through cable and device detection

Devices per SCSI channel

Up to 15 wide or seven non-wide SCSI devices.
Up to 6 non-disk SCSI drives per RAID Controller
Kit-G controller.

SCSI device types supported

Synchronous or asynchronous. Disk and non-disk.

RAID levels supported

0, 1, 5, 10, and 50

SCSI connectors

One 68-pin internal high-density connector for
16-bit SCSI devices. One very-high density 68-pin
external connector for Ultra and Wide SCSI.

Serial port

3-pin RS232C-compatible berg

PCI Bridge/CPU

RAID Controller Kit-G uses the Intel GC80302 PCI bridge with an embedded 80960JT
RISC processor running at 66 MHz. The GC80302 bridge handles data transfers
between the primary (host) PCI bus, the secondary PCI bus, cache memory, and the
SCSI bus. The DMA controller supports chaining and unaligned data transfers. The
embedded 80960JT CPU directs all controller functions, including command
processing, SCSI bus transfers, RAID processing, drive rebuilding, cache management,
and error recovery.

This manual is related to the following products: