beautypg.com

High-density single ended connector – Toshiba Magnia 560S User Manual

Page 220

background image

SCSI Cables and Connectors

202

SCSI Cables and Connectors

Table A.3 High-Density 68-Pin SCSI Connector Pinout (Continued)

Signal

Connector
Pin

Cable
Pin

Cable
Pin

Connector
Pin

Signal

Ground

28

55

56

62

-C/D

Ground

29

57

58

63

-REQ

Ground

30

59

60

64

-I/O

Ground

31

61

62

65

-DB(8)

Ground

32

63

64

66

-DB(9)

Ground

33

65

66

67

-DB(10)

Ground

34

67

68

68

-DB(11)

High-Density Single Ended Connector

The following applies to the high-density SCSI connector table on the previous page:

A hyphen before a signal name indicates that signal is active low.

The connector pin refers to the conductor position when using 0.025 inch centerline
flat ribbon cable with a high-density connector (AMPLIMITE.050 Series
connectors).

Eight-bit devices connected to the P-Cable must leave the following signals open:
-DB (8), -DB (9), -DB (10), -DB (11), -DB(12), -DB (13), -DB (14), -DB 15), and
-DB (P1).

All other signals should be connected as defined.

CAUTION: Lines labeled RESERVED should be connected to Ground in the
bus terminator assemblies or in the end devices on the SCSI cable.

RESERVED lines should be open in the other SCSI devices, but can be
connected to Ground.

This manual is related to the following products: