Installation steps – Toshiba Magnia 560S User Manual
Page 78
Installation Steps
60
Hardware Installation
Table 6.1 Checklist for Installation (Continued)
Check
Step
Action
8
Format the hard disk drives as needed.
9
Configure system drives (logical drives).
10
Initialize the logical drives.
11
Install the network operating system drivers as needed.
Installation Steps
RAID Controller Kit-G provides extensive customization options. If you need only
basic RAID Controller Kit-G features and your computer does not use other adapter
cards with resource settings that may conflict with RAID Controller Kit-G settings,
even custom installation can be quick and easy.
Table 6.2 lists the installation steps. Each step is described in detail in the following
pages.
Table 6.2 RAID Controller Kit-G Installation Steps
Step Action
Additional Information
1
Unpack the MegaRAID controller and
inspect for damage. Make sure all items
are in the package.
If damaged, call your Toshiba OEM
support representative.
2
Turn the computer off, remove the power
cord and remove the cover.
3
Make sure the motherboard jumper
settings are correct.
4
Check the jumper settings on the RAID
Controller Kit-G controller.
See page 43 for the RAID Controller
Kit-G jumper settings.
5
Set SCSI termination.
6
Install the RAID Controller Kit-G card.
7
Connect the SCSI cables to SCSI devices.
8
Set the target IDs for the SCSI devices.
9
Replace the computer cover and turn the
power on.
Be sure the SCSI devices are
powered up before or at the same
time as the host computer.
10
Run the MegaRAID BIOS Configuration
Utility.
Optional.
11
Install software drivers for the desired
operating systems.