Toshiba Magnia 560S - Manual (Page 146)

Adapter Properties 128
WebBIOS Configuration Utility
Table 10.2 Adapter Properties (Continued)
Option Description
Flex RAID
PowerFail Select this option to enable or disable the FlexRAID PowerFail
feature. This option allows drive reconstruction to continue when
the system restarts because of a power failure.
Alarm Control Select this option to enable, disable, or silence the onboard alarm
tone generator.
Adapter BIOS Select this option to enable or disable the BIOS on the adapter.
Set Factory
Defaults Enable this option to load the default MegaRAID WebBIOS
Configuration Utility settings.
Battery
Backup Indicates whether the battery backup is present or absent.
BIOS Stops on
Error When set to On (the default), the BIOS stops in case of a problem
with the configuration. This gives you the option to enter the
configuration utility to resolve the problem.
BIOS Echoes
Messages When set to On (the default), all controller BIOS messages display
during bootup.
BIOS Config
AutoSelection Use this option so that if there is a mismatch between the drives and
NVRAM, you can select a method to resolve it. The options are
NVRAM, Disk, and User.
Spinup
Parameters Use this option to set the timing for spinning up the hard disk drives
in the computer. The options are Automatic, 2 per sec, 4 per sec, or
6 per sec.
Fast
Initialization When enable (the default), zeros are written to the first sector of the
logical drive so that initialization occurs in 2 - 3 seconds.
PCI Trans
Delay
Auto Rebuild Enable this option to automatically rebuild drives when they fail.
Class
Emulation
Mode You can select this option to operate in I2O or mass storage mode.