Brocade Communications Systems Brocade ICX 6650 - Manual (Page 75)

Brocade ICX 6650 Administration Guide 57
53-1002600-01
Loading and saving configuration files
3
Syntax: show boot-preference
The results of the show run command for the configured example above appear as follows.
Brocade#show run
Current configuration:
!
ver 07.5.00B1T323
!
stack unit 1
module 1 icx6650-64-56-port-management-module
module 2 icx6650-64-4-port-160g-module
module 3 icx6650-64-8-port-80g-module
!
!
trunk ethe 1/2/1 to 1/2/2
trunk ethe 1/2/3 to 1/2/4
!
vlan 1 name DEFAULT-VLAN by port
!
vlan 10 by port
!
vlan 20 by port
!
!
!
!
traffic-policy TPD1 rate-limit fixed 125 exceed-action Drop
!
!
!
!
fpod-40g-enable group 2
optical-monitor
chassis poll-time 200
ip show-portname
ip route 0.0.0.0 0.0.0.0 10.21.112.1
!
logging console
fdp run
!
!
router pim
!
end
Loading and saving configuration files
For easy configuration management, all Brocade devices support both the download and upload of
configuration files between the devices and a TFTP server on the network.
You can upload either the startup configuration file or the running configuration file to the TFTP
server for backup and use in booting the system:
• Startup configuration file – This file contains the configuration information that is currently
saved in flash. To display this file, enter the show configuration command at any CLI prompt.