Displaying ipv6 interface information – Brocade Communications Systems Brocade ICX 6650 User Manual
Page 159
Brocade ICX 6650 Administration Guide
141
53-1002600-01
Displaying global IPv6 information
5
Syntax: show ipv6 cache [
ethernet
The
and subsequent entries.
The
IPv6 prefix. You must specify the
between colons as documented in RFC 2373. You must specify the
decimal value. A slash mark (/) must follow the
The ethernet | ve | tunnel parameter restricts the display to the entries for the specified interface.
The
You must specify this parameter in hexadecimal using 16-bit values between colons as
documented in RFC 2373.
Specify the ethernet port in the
VE interface, also specify the VE number. If you specify a tunnel interface, also specify the tunnel
number.
This display shows the following information.
Displaying IPv6 interface information
To display IPv6 interface information, enter the following command at any CLI level.
TABLE 28
IPv6 cache information fields
Field
Description
Total number of cache entries
The number of entries in the cache table.
IPv6 Address
The host IPv6 address.
Next Hop
The next hop, which can be one of the following:
•
Direct – The next hop is directly connected to the router.
•
Local – The next hop is originated on this router.
•
Port
The port on which the entry was learned.
Brocade#show ipv6 cache
Total number of cache entries: 10
Total number of cache entries: 10
IPv6 Address Next Hop Port
1 2001:DB8::2 LOCAL tunnel 2
2 2001:DB8::106 LOCAL ethe 1/1/1
3 2001:DB8::110 DIRECT ethe 1/1/2
4 2001:DB8:46a::1 LOCAL ethe 1/1/3
5 2001:DB8::2e0:52ff:fe99:9737 LOCAL ethe 1/1/4
6 2001:DB8::fff:ffff:feff:ffff LOCAL loopback 2
7 2001:DB8::c0a8:46a LOCAL tunnel 2
8 2001:DB8::c0a8:46a LOCAL tunnel 6
9 2001:DB8::1 LOCAL loopback 2
10 2001:DB8::2e0:52ff:fe99:9700 LOCAL ethe 1/1/5