Brocade Communications Systems Brocade ICX 6650 - Manual (Page 186)

168 Brocade ICX 6650 Administration Guide
53-1002600-01
Displaying SNMP Information
6
Displaying SNMP groups
To display the definition of an SNMP group, enter a command such as the following.
Brocade#show snmp group
groupname = exceptifgrp
security model = v3
security level = authNoPriv
ACL id = 2
readview = exceptif
writeview =
Syntax: show snmp group
The value for security level can be one of the following.
Displaying user information
To display the definition of an SNMP user account, enter a command such as the following.
Syntax: show snmp user
Interpreting varbinds in report packets
If an SNMP version 3 request packet is to be rejected by an SNMP agent, the agent sends a report
packet that contains one or more varbinds. The varbinds contain additional information, showing
the cause of failures. An SNMP manager application decodes the description from the varbind. The
following table presents a list of varbinds supported by the SNMP agent.
Security level Authentication
If the security model shows v1 or v2, then security level is blank. User names are not
used to authenticate users; community strings are used instead.
noauthNoPriv Displays if the security model shows v3 and user authentication is by user name only.
authNoPriv Displays if the security model shows v3 and user authentication is by user name and the
MD5 or SHA algorithm.
Brocade#show snmp user
username = bob
ACL id = 2
group = admin
security model = v3
group ACL id = 0
authtype = md5
authkey = 3aca18d90b8d172760e2dd2e8f59b7fe
privtype = des, privkey = 1088359afb3701730173a6332d406eec
engine ID= 800007c70300e052ab0000