Disabling or re-enabling syslog, Specifying a syslog server – Brocade Communications Systems Brocade ICX 6650 User Manual
Page 256
238
Brocade ICX 6650 Administration Guide
53-1002600-01
Syslog service configuration
10
Disabling or re-enabling Syslog
Syslog is enabled by default. To disable it, enter the logging on command at the global CONFIG
level.
Brocade(config)#no logging on
Syntax: [no] logging on [
The
514.
To re-enable logging, re-enter the logging on command.
Brocade(config)#logging on
This command enables local Syslog logging with the following defaults:
•
Messages of all severity levels (Emergencies – Debugging) are logged.
•
Up to 50 messages are retained in the local Syslog buffer.
•
No Syslog server is specified.
Specifying a Syslog server
To specify a Syslog server, enter the logging host command.
Brocade(config)#logging host 10.0.0.99
Syntax: logging host
Brocade#show logging
Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)
Buffer logging: level ACDMEINW, 16 messages logged
level code: A=alert C=critical D=debugging M=emergency E=error
I=informational N=notification W=warning
Static Log Buffer:
0d00h00m17s:I:System: Stack unit 1 Power supply 2 is up
0d00h00m14s:A:System: Stack unit 1 Temperature 53.0 C degrees, warning level 0.0
C degrees, shutdown level 85.0 C degrees
0d00h00m14s:W:System: Temperature is over warning level on unit 1
Dynamic Log Buffer (50 lines):
3d00h21m29s:I:running-config was changed by from console
2d21h52m07s:I:running-config was changed by from console
1d11h35m29s:I:VLAN: Id 20 deleted by user from console session
1d02h42m03s:I:running-config was changed by from console
0d00h01m38s:D:DHCPC: Stopped DHCP Client service
0d00h00m14s:I:System: Interface ethernet 1/2/4, state up
0d00h00m14s:I:System: Interface ethernet 1/2/3, state up
0d00h00m14s:I:System: Interface ethernet 1/2/2, state up
0d00h00m14s:I:System: Interface ethernet 1/2/1, state up
0d00h00m14s:I:System: Interface ethernet mgmt1, state up
0d00h00m08s:D:DHCPC: starting dhcp client service on 69 port(s)