Brocade Communications Systems Brocade ICX 6650 User Manual
Page 294
276
Brocade ICX 6650 Administration Guide
53-1002600-01
Syslog messages
A
Alert
Temperature
level
level
Indicates an over temperature condition on
the active module.
The
temperature of the module.
The
threshold temperature configured for the
module.
The
shutdown temperature configured for the
module.
Critical
Authentication shut down
DOS attack
Denial of Service (DoS) attack protection
was enabled for multi-device port
authentication on the specified
and the per-second rate of RADIUS
authentication attempts for the port
exceeded the configured limit. The Brocade
device considers this to be a DoS attack
and disables the port.
Debug
BGP4: Not enough memory available to run
BGP4
The device could not start the BGP4 routing
protocol because there is not enough
memory available.
Debug
DOT1X: Not enough memory
There is not enough system memory for
802.1X authentication to take place.
Contact Brocade Technical Support.
Error
No of prefixes received from BGP peer
prefix-limit...shutdown
The Layer 3 Switch has received more than
the specified maximum number of prefixes
from the neighbor, and the Layer 3 Switch is
therefore shutting down its BGP4 session
with the neighbor.
Informational
IPv6: IPv6 protocol disabled on the device
from
IPv6 protocol was disabled on the device
during the specified session.
Informational
IPv6: IPv6 protocol enabled on the device
from
IPv6 protocol was enabled on the device
during the specified session.
Informational
MAC Filter applied to port
id=
Indicates a MAC address filter was applied
to the specified port by the specified user
during the specified session.
web, or snmp.
filters that were applied.
Informational
MAC Filter removed from port
id=
Indicates a MAC address filter was removed
from the specified port by the specified user
during the specified session.
web, or snmp.
filters that were removed.
TABLE 57
Brocade Syslog messages (Continued)
Message level
Message
Explanation