Brocade Communications Systems Brocade ICX 6650 User Manual

Page 299

Brocade ICX 6650 Administration Guide

281

53-1002600-01

Syslog messages

Informational

SNMP Auth. failure, intruder IP:

A user has tried to open a management
session with the device using an invalid
SNMP community string.
The is the IP address of the host
that sent the invalid community string.

Informational

SSH | telnet server enabled | disabled from
console | telnet | ssh | web | snmp session
[by user ]

A user enabled or disabled an SSH or Telnet
session, or changed the SSH
enable/disable configuration through the
Web, SNMP, console, SSH, or Telnet
session.

Informational

startup-config was changed
or
startup-config was changed by

A configuration change was saved to the
startup-config file.
The is the user ID, if they
entered a user ID to log in.

Informational

STP: Root Guard Port , VLAN
consistent (Timeout).

Root guard unblocks a port.

Informational

STP: Root Guard Port , VLAN
inconsistent (Received superior
BPDU).

Root guard blocked a port.

Informational

STP: VLAN BPDU-Guard on Port
triggered (Received BPDU), putting
into err-disable state

The BPDU guard feature has detected an
incoming BPDU on {vlan-id, port-id}

Informational

STP: VLAN Root-Protect Port id>, Consistent (Timeout)

The root protect feature goes back to the
consistent state.

Informational

STP: VLAN Root-Protect Port id>, Inconsistent (Received superior BPDU)

The root protect feature has detected a
superior BPDU and goes into the
inconsistent state on {vlan-id, port-id}.

Informational

STP: VLAN BPDU-guard port
detect (Received BPDU),
putting into err-disable state

STP placed a port into an errdisable state
for BPDU guard.

Informational

STP: VLAN 1 BPDU-guard port
detect (Received BPDU),
putting into err-disable state.

BPDU guard violation in occurred in STP or
RSTP.

Informational

A user made Syslog configuration changes
to the specified Syslog server address, or
enabled or disabled a Syslog operation
through the Web, SNMP, console, SSH, or
Telnet session.

Informational

SYSTEM: Optic is not Brocade-qualified
()

Brocade does not support the optical
transceiver.

Informational

System: Fan (from left when facing
right side), ok

The fan status has changed from fail to
normal.

Informational

System: Fan speed changed automatically to

The system automatically changed the fan
speed to the speed specified in this
message.

Informational

System: No free TCAM entry. System will be
unstable

There are no TCAM entries available.

TABLE 57

Brocade Syslog messages (Continued)

Message level

Message

Explanation