Brocade Communications Systems Brocade ICX 6650 User Manual
Page 69
Brocade ICX 6650 Administration Guide
51
53-1002600-01
Software versions installed and running on a device
3
UNIT 1: SL 1: ICX6650-64 56-port Management Module
Serial #: CEN2525H006
License: BASE_SOFT_PACKAGE (LID: egpHKHKjFFL)
P-ENGINE 0: type EC02, rev 01
==========================================================================
UNIT 1: SL 2: ICX6650-64 4-port 160G Module
==========================================================================
UNIT 1: SL 3: ICX6650-64 8-port 80G Module
==========================================================================
800 MHz Power PC processor 8544E (version 0021/0022) 400 MHz bus
65536 KB flash memory
1024 MB DRAM
STACKID 1 system uptime is 23 hours 12 minutes 8 seconds
==========================================================================
HARDWARE INFORMATION
UNIT NAME : ICX6650-64
HW REVISION : 2 (BETA)
Board ID : 4(ICX6650)
CPLD INFORMATION
CPLD code is RD revision
CPLD CODE REVISION = 6
==========================================================================
The system : started=warm start reloaded=by "reload"
*** NOT FOR PRODUCTION ***
The version information is shown in bold type in this example:
•
“07.5.00T321” indicates the flash code version number. The “T321” is used by Brocade for
record keeping.
•
“labeled as ICXLS07500” indicates the flash code image label. The label indicates the image
type and version and is especially useful if you change the image file name.
•
“Secondary ICXLS07500.bin” indicates the flash code image file name that was loaded.
Displaying the boot image version running on the device
To determine the boot image running on a device, enter the show flash command at any level of the
CLI. The following shows an example output.
Brocade#show flash
Stack unit 1:
Compressed Pri Code size = 12849087, Version:07.5.00áT323 (ICXLR07500B1.bin)
Compressed Sec Code size = 12848889, Version:07.5.00T323 (ICXLR07500b1.bin)
Compressed Boot-Monitor Image size = 524288, Version:07.5.00T7f5
Code Flash Free Space = 21843968
The boot code version is shown in bold type.
Displaying the image versions installed in flash memory
Enter the show flash command to display the boot and flash images installed on the device. An
example of the command output is shown in
“Displaying the boot image version running on the
•
The “Compressed Pri Code size” line lists the flash code version installed in the primary flash
area.