Brocade Communications Systems Brocade ICX 6650 - Manual (Page 31)

Brocade ICX 6650 Administration Guide 13
53-1002600-01
Chapter
2
Basic Software Features
In this chapter
• Basic system parameter configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
• Specifying an SNTP server . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
• Configuring the device as an SNTP server. . . . . . . . . . . . . . . . . . . . . . . . . . . 23
• Basic port parameter configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31
Table 4 lists the Brocade ICX 6650 switch and the basic software features the switch supports.
These features are supported in full Layer 3 software images, except where explicitly noted.
TABLE 4 Supported basic software features
Feature Brocade ICX
6650
Basic System Parameters
System name, contact, and location Yes
SNMP trap receiver and trap source
address Yes
Virtual routing interface statistics via
SNMP Yes
Disable Syslog messages and traps for CLI
access Yes
Cancelling an outbound Telnet session Yes
System time using a Simple Network Time
Protocol (SNTP) server or local system
counter Yes
Enabling broadcast mode for SNTP client Yes
System clock Yes
Packet-based broadcast, multicast, and
unknown-unicast limits Yes
CLI banners Yes
Local MAC address for Layer 2
management traffic Yes
Basic Port Parameters
Port name Yes
10/100/1000 port speed Yes
Auto-negotiation Yes
Auto-negotiation maximum port speed
advertisement and down-shift Yes