Brocade Communications Systems Brocade ICX 6650 - Manual (Page 157)

Brocade ICX 6650 Administration Guide 139
53-1002600-01
Clearing global IPv6 information
5
Clearing the IPv6 cache
You can remove all entries from the IPv6 cache or specify an entry based on the following:
• IPv6 prefix.
• IPv6 address.
• Interface type.
For example, to remove entries for IPv6 address 2001:DB8::1, enter the following command at the
Privileged EXEC level or any of the Config levels of the CLI.
Brocade#clear ipv6 cache 2001:DB8::1
Syntax: clear ipv6 cache [/ | | ethernet
//| tunnel | ve ]
You must specify the parameter in hexadecimal using 16-bit values between colons
as documented in RFC 2373. You must specify the parameter as a decimal value. A
slash mark (/) must follow the parameter and precede the
parameter.
You must specify the parameter in hexadecimal using 16-bit values between
colons as documented in RFC 2373.
The ethernet | tunnel | ve parameter specifies the interfaces for which you can remove cache
entries. Specify the Ethernet port in the // format. Stack-unit is 1. If you
specify a VE or tunnel interface, also specify the VE or tunnel number, respectively.
Clearing IPv6 neighbor information
You can remove all entries from the IPv6 neighbor table or specify an entry based on the following:
• IPv6 prefix
• IPv6 address
• Interface type
For example, to remove entries for Ethernet interface 1/2/1, enter the following command at the
Privileged EXEC level or any of the CONFIG levels of the CLI.
Brocade#clear ipv6 neighbor ethernet 1/2/1
Syntax: clear ipv6 neighbor [/ | | ethernet
//| ve ]
You must specify the parameter in hexadecimal using 16-bit values between colons
as documented in RFC 2373. You must specify the parameter as a decimal value. A
slash mark (/) must follow the parameter and precede the
parameter.
You must specify the parameter in hexadecimal using 16-bit values between
colons as documented in RFC 2373.
The ethernet | ve parameter specifies the interfaces for which you can remove cache entries.
Specify the // format. Stack-unit is 1. If you specify a VE, also specify the
VE number.