Brocade Communications Systems Brocade ICX 6650 User Manual
Page 218
200
Brocade ICX 6650 Administration Guide
53-1002600-01
LLDP configuration
8
•
Management address
•
Port description
•
System capabilities
•
System description (not automatically advertised)
•
System name
Management Address
A management address is normally an IPv4 or IPv6 address that can be used to manage the
device. Management address advertising has two modes: default, or explicitly configured. The
default mode is used when no addresses are configured to be advertised for a given port. If any
addresses are configured to be advertised for a given port, then only those addresses are
advertised. This applies across address types, so for example, if just one IPv4 address is explicitly
configured to be advertised for a port, then no IPv6 addresses will be advertised for that port (since
none were configured to be advertised), even if IPv6 addresses are configured within the system.
If no management address is explicitly configured to be advertised, the Brocade ICX 6650 device
will use the first available IPv4 address and the first available IPv6 address (so it may advertise
IPv4, IPv6 or both). A Layer 3 switch will select the first available address of each type from those
configured on the following types of interfaces, in the following order of preference:
•
Physical port on which LLDP will be transmitting the packet
•
Virtual router interface (VE) on a VLAN that the port is a member of
•
Dedicated management port
•
Loopback interface
•
Virtual router interface (VE) on any other VLAN
•
Other physical port
•
Other interface
For IPv6 addresses, link-local and anycast addresses will be excluded from these searches.
If no IP address is configured on any of the above, the port's current MAC address will be
advertised.
To advertise a IPv4 management address, enter a command such as the following:
Brocade(config)#lldp advertise management-address ipv4 10.157.2.1 ports e 1/1/1
The management address will appear similar to the following on the remote device, and in the CLI
display output on the Brocade device (show lldp local-info):
Management address (IPv4): 10.157.2.1
Syntax: [no] lldp advertise management-address ipv4
To support an IPv6 management address, there is a similar command that has equivalent behavior
as the IPv4 command.
To advertise an IPv6 management address, enter a command such as the following:
Brocade(config)#lldp advertise management-address ipv6 2001:DB8:90 ports e 1/1/3
Syntax: [no] lldp advertise management-address ipv6