Kramer Electronics WP-501 - Manual (Page 93)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the RC-6X Series Room Controller as a Standalone Device
86
Figure 179: Load Firmware Upgrade Window
8. Click Start Upgrade.
9. Upon completion, open the Device Settings Tab to make sure the firmware was upgraded
1
10.3 The Help Menu
.
Figure 18 illustrates the Help menu and 0 Table 1 defines it: 8
Figure 180: The Help Menu
Table 18: Help Menu Features
Menu Command Function
Check for updates Check on the Kramer Electronics Web site for software
updates.
About Kramer K-Config Shows the current software version.
11 Connecting the RC-6X Series Room Controller as a Standalone Device
You can configure the Room Controller to be used as a standalone device. To do this you have to
connect the Room controller directly to your PC via the USB connector.
To define an RC-6X as a Master device:
1. From the Device Menu, click Connect….
2. Select the connection method to be USB, select the port and click OK.
The following warning appears:
Figure 181: Transforming to the Standalone Configuration
3. Click Yes.
When in the standalone mode, you can write the actions directly to RC-6X by clicking the Write
Configuration button.
To exit the standalone mode open the Device menu and select Set as Aux.
1 If the firmware number remains the same, close the Device Properties windows, disconnect and then reconnect the device, and open the Device Properties
window again to check the Firmware number