Kramer Electronics WP-501 - Manual (Page 26)

Tab Area Settings
19
5 Tab Area Settings
The tab area includes the:
• Machine front panel – shows the front panel of the selected machine and if available, lets
you configure a button trigger
• Port Manager (see Section 5.1
• Device Settings (see
)
Section 5.2
• Web settings (see
)
Section 5.3
5.1 Defining the Port Manager
)
The Port Manager tab defines the ports on the selected K-NET device (Master RC or Aux K-NET
device) or standalone room controller and lets you write a description and assign a default driver to
each port.
Note that ports on auxiliary devices can be used only for sending outgoing commands from the
auxiliary device to an AV device. If you need to use Monitor event triggers or Queries functions,
which rely on bidirectional communication, connect the AV device to the K-Net master device.
For similar reasons, GPI/O ports on the auxiliary devices will be disabled.
To define the port manager (for example, a projector driver that is connected to the RS-232 9-pin
D-sub port of an SV-552), do the following:
1. In the Control Room area, select 1-SV-552.
2. Select the Port Manager tab.
Figure 25: The Port Manager
3. Click the Driver area next to [1-SV-552] RS-232.D_Type.
4. The following window opens: