Kramer Electronics WP-501 - Manual (Page 14)

Kramer K-Config Software Installation
7
1.9 Defining the System
This section defines the minimum requirements for the Kramer K-Config and describes how to
install your system.
1.9.1 System Requirements for the Kramer K-Config
The system minimum requirements include:
• 400MHz or faster processor
• 128MB or more RAM
• At least 300MB free hard disk space
• Network connection for configuring devices or USB
• Microsoft.NET® Framework 2.0 Service Pack 1, automatically installed (see Section 2.1
1.9.2 Operating Systems
)
Microsoft® Windows XP®, Microsoft Vista (32 or 64 bit) or Microsoft Windows 7 (32 or 64 bit)
are the recommended operating systems 1
2 Kramer K-Config Software Installation
. Other Windows versions are not supported.
To install the software, do the following:
• Check that “.NET Framework” Revision 2.0 software is installed or install it if it is missing
(see Section 2.1
• Install the USB driver (see
)
Section 2.2
• Install the Kramer K-Config software (see
)
Section 2.3
2.1 Installing the “.NET Framework” Revision 2.0 Software
)
Prior to using the Kramer K-Config software, make sure that the “.NET Framework” Revision 2.0
software is installed on your PC. If it is not, you need to install it:
• If you have a fast Internet connection, this software is automatically installed during the
installation of the Kramer K-Config software
• If you do not have a fast Internet connection, insert the CD-ROM into the CD-ROM drive,
double click the dotnetfx.exe 2 file and follow the on-screen instructions 3
2.2 Installing the USB Driver
If you wish to configure the RC device by connecting it via a USB cable, you need to download and
install the USB driver. Otherwise you will be prompted to do so when starting the Kramer
K-Config software:
Figure 2: USB Driver Notice
Install the Kramer USB driver from the installation disc or from our Web site at
http://www.kramerelectronics.com/support/downloads.asp .
1 Windows NT does not support .NET 2.0 and cannot be used
2 File names are liable to change
3 Installation may take about 15 minutes