Kramer Electronics WP-501 - Manual (Page 82)

The Driver Manager
75
9.2.1 Setting the Query Details (for Lamp Hours)
The protocol of the main display determines the format in which the numerical value response to
the Lamp hours query is received. This response can appear in one of three formats, as defined in
Table 11 :
Table 11: Lamp Hour Query Response Formats
Main Display Response
format
Example
(for lamp hours)
In the Query Format Table: Set Format to:
As a numerical string “1979” or
0x31,0x39,0x37,0x39
Select the first three fields in the window to cut the
relevant chars from the response
ASCII
As a hexadecimal numerical
string
“7BB” or
0x37,0x42,0x42
Select the first three fields in the window to cut the
relevant chars from the response
ASCII_16
As Byte values 0x07,0xBB (big
Endian)
Select the first three fields in the window to cut the
relevant bytes
If the byte with the highest value is first, select the Endian
byte to be Big Endian; if the lowest byte is first, select
Little Endian
BINARY_HEX
The following example shows how to set a projector Lamp Hour query.
To open the Query Details window:
1. Select the Lamp Hour query in the Queries area:
Figure 160: Queries Area
2. Click the Query Details button. The Query Details window appears:
Figure 161: Query Details Window
3. In the Query Command Details tab, type the query command (for example, 03H 8CH 00H 00H
00H 8FH 1
1 The command written is specific to the projector used, and can be found in the protocol for that projector
) that will be sent to the projector: