Kramer Electronics WP-501 - Manual (Page 36)

The Triggers
29
6.2 Adding Actions to a Trigger
To add actions to a trigger (for example, to the built-in All On trigger), do the following:
1. In the Trigger area, select the All On trigger.
2. Select the Action Type
1 (for example, Port Command).
Figure 45: Selecting the Action Type (Port Command in this example)
3. Select the desired port (for example, RS-232.D_Type):
Figure 46: Selecting the Port
As illustrated in Figure 46 , the SV-552, RC-63AL, RC-63DL and SL-12 ports appear in the list
because they are included in the system. Each action type shows the relevant commands for all
the machines included in the system. In this example, the system includes SV-552, RC-63DL,
RC-4 (see Section 4.1.2 ), RC-63AL, SL-12, RC-53DLC and 2 Virtual Devices (see
4.1.1
Section
4. Select the Command (for example, Power: On):
). The Port Command includes actions for the SV-552, RC-63DL, RC-63AL and SL-12
(there are no ports on the RC-4, RC-53DLC or the Virtual Device).
1 Selecting an Action Type from the list displays the list of its available commands