Kramer Electronics WP-501 - Manual (Page 2)

Contents
i
1 Introduction 1
Contents
1.1 Applicable Room Controllers 1
1.2 Available Commands for Room Control Ports 2
1.3 Trigger Types Available 3
1.4 Actions, Labels and Button Number Limits 4
1.5 How to Save a Project 4
1.6 Quick Start 5
1.7 Initial Planning 6
1.8 Glossary 6
1.9 Defining the System 7
1.9.1 System Requirements for the Kramer K-Config 7
1.9.2 Operating Systems 7
2 Kramer K-Config Software Installation 7
2.1 Installing the “.NET Framework” Revision 2.0 Software 7
2.2 Installing the USB Driver 7
2.3 Installing Kramer K-Config Software 8
3 The Peripheral Device Drivers 9
3.1 Downloading the Drivers 9
3.2 Importing xml Templates 9
3.3 Importing the Drivers 9
4 Defining the Control Room 11
4.1 Special Auxiliary Devices 14
4.1.1 The Virtual Device – Compatible with SL-1, SL-10, SL-12, SL-14RC, RC-74DL, SV-551 and SV-552 14
4.1.2 The RC-4 Remote Controller – Compatible with SL-1, SL-10, SL-12 and SV-552 18
5 Tab Area Settings 19
5.1 Defining the Port Manager 19
5.1.1 Defining the Ethernet Ports 22
5.1.2 Setting the Volume Properties 23
5.1.3 Uploading EDID Information 23
5.2 The Device Settings Tab 24
5.2.1 Setting the Date and Time 25
5.3 The Web Settings Tab 27
6 The Triggers 28
6.1 The Built-in Triggers 28
6.2 Adding Actions to a Trigger 29
6.3 Replacing an Action 31
6.4 Adding a Custom Trigger 33
6.5 Set the Schedule 34
6.6 The Monitor Event Trigger 35
6.7 The Add Timer Trigger 36
6.7.1 Power ON Example 36
6.7.2 System Inactivity Example 40
6.8 The GPI/O Trigger 43
6.8.1 Digital Input 44
6.8.2 Digital Output 46
6.8.3 Analog Input 46
6.9 The Button Trigger 47
6.9.1 Button Behavior 48
6.10 The Knob Turning Trigger 50
6.11 Action Type 50
6.11.1 The Port Command Action Type 50
6.11.2 The Relay Command (Port Switch) Action Type 51