Sony ICD-R100VTP - Manual (Page 98)

C H A P T E R 5 Editing and Revising Text
Dragon NaturallySpeaking User’s Guide 92
You can also say “Select Again” if Dragon NaturallySpeaking selects a
word that sounds like but is not the word you want (for example, “two”
instead of “too”).
Unselecting words
If the wrong text is selected, say “Unselect That.”
You can also “unselect” words by moving your insertion point (by mouse
or voice) to another part of your document. For example, say “Go to End
of Line” or click somewhere else in your document.
A third way to unselect words is to use the “Select” command to select
different text.
Selecting a longer phrase
You can select a longer phrase for correction by saying “Select [text]
Through [text]” (
US/Canada ) or “Select [text] To [text]” ( Other Dialects ). For
[text], substitute the actual word or words at the beginning and the end
of the range of wrong words. If the phrase was the last thing you said,
you can just say “Select That.”
Once the phrase is selected, you can edit and correct it in the Correction
dialog box.
If you’re correcting more than one word, the words must all be in sequence
(next to each other). You can’t use a single command to correct words that are in different
parts of your document.
Is “That” Too Much?
Saying “Select That,” “Spell That,” or “Correct That” to correct your
last phrase is practical only when the phrase contains up to 5 words
or 50 characters. A much longer phrase may not fit completely in the
Quick Correct list, or even in the Correction dialog box, and it’s
more difficult to find a correct alternative in the vocabulary lists for a
long phrase.
To fix mistakes in a long phrase or sentence, it is best to correct just
the specific wrong words using the techniques discussed in this
section.
NOTE
UG5.bk Page 92 Friday, August 4, 2000 2:26 PM