Allied Telesis AT-S62 - Manual (Page 59)

AT-S62 Command Line User’s Guide
59
SHOW DHCPBOOTP
Syntax
show dhcpbootp
Parameters
None.
Description
This command displays the status of the DHCP and BOOTP client
software on the switch. The status will be either “enabled” or “disabled.”
The default setting is disabled.
To enable the DHCP and BOOTP client software, refer to ENABLE
DHCPBOOTP on page 40 or ENABLE IP REMOTEASSIGN on page 41. To
disable the client software, refer to DISABLE DHCPBOOTP on page 37 or
DISABLE IP REMOTEASSIGN on page 38.
Example
The following command displays the status of the DHCP and BOOTP
client software:
show dhcpbootp