Allied Telesis AT-S62 - Manual (Page 245)

AT-S62 Command Line User’s Guide
245
SET DOS TEARDROP
Syntax
set dos teardrop port=port state=enable|disable
[mirrorport=auto|port]
Parameters
port Specifies the switch ports on which you want to
enable or disable this DoS defense. You can select
more than one port at a time.
state Specifies the state of the DoS defense. The options
are:
enable Activates the defense.
disable Deactivates the defense. This is the default.
mirrorport Specifies a port where invalid traffic is copied. You can
specify only one port.
Description
This command activates and deactivates the Teardrop DoS defense.
In this DoS attack, an attacker sends a packet in several fragments with a
bogus offset value, used to reconstruct the packet, in one of the
fragments to a victim. This results in the victim being unable to
reassemble the packet, possibly causing it to freeze operations.
The defense mechanism for this type of attack has all ingress IP traffic
received on a port sent to the switch’s CPU. The CPU samples related,
consecutive fragments, checking for fragments with invalid offset
values. If one is found, the following occurs:
❑ The switch sends a trap to the management workstations.
❑ The switch port discards the fragment with the invalid offset and,
for a one minute period, discards all ingress IP fragments on the
port.
Since the CPU examines only a sampling of the ingress IP traffic on a
port, there is no guarantee that the switch will caught or prevent this
type of attack.