Allied Telesis AT-S62 - Manual (Page 187)

AT-S62 Command Line User’s Guide
187
SET SWITCH MIRROR
Syntax
set switch mirror=port
Parameter
mirror Specifies the destination port for the port mirror. This is the
port where the traffic from the source ports will be copied.
You can specify only one port as the destination port.
Specifying “0” (zero) disables port mirroring.
Description
This command enables mirroring and specifies the destination port, or
disables mirroring. To select the source ports, refer to SET SWITCH PORT
MIRROR on page 188.
Example
The following command enables mirroring and makes port 11 the
destination port:
set switch mirror=11
The following command disables port mirroring:
set switch mirror=0