Allied Telesis AT-S62 - Manual (Page 135)

AT-S62 Command Line User’s Guide
135
Description
This command modifies an SNMPv3 Target Address Table entry.
Examples
The following command modifies the Target Address Table entry with a
value of “snmphost.” The params parameter is set to “targetparameter7”
and the IP address is 198.1.1.1. The taglist is set to “systemtesttraptag”
and “systemtestinformtag.”
set snmpv3 targetaddr=snmphost
params=targetparameter7 ipaddress=198.1.1.1
taglist=systemtesttraptag systemtestinformtag
The following command modifies the Target Address Table entry with a
value of “host.” The params parameter is set to “targetparameter22” and
the IP address is 198.1.1.198. The taglist is set to “engineeringtraptag”
and “engineeringinformtag.”
set snmpv3 targetaddr=host
params=targetparameter22 ipaddress=198.1.1.198
taglist=engineeringtraptag engineeringinformtag