Allied Telesis AT-S62 - Manual (Page 394)

Chapter 31: TACACS+ and RADIUS Commands
394
ADD RADIUSSERVER
Syntax
add radiusserver server|ipaddress=ipaddress
order=value [secret=string] [port|accport=value]
[accport=value]
Parameters
server Specifies an IP address of a RADIUS server. The parameters
ipaddress are equivalent.
order Specifies the order that the RADIUS servers are queried by
the switch. This value can be from 1 to 3. The servers are
queried starting with 1.
secret Specifies the encryption key used for this server.
port Specifies the UDP (User Datagram Protocol) port of the
accport RADIUS server. The default is port 1813. The parameters are
equivalent.
Description
Use this command to specify the IP addresses of RADIUS servers and the
order they are to be queried by the switch. There can be up to three
servers, but you can specify only one at a time with this command. You
may specify an encryption key, a RADIUS UDP port, and a RADIUS
accounting UDP port.
Examples
The following command adds a RADIUS server with the 149.245.22.22 IP
address and specifies it as the first server in the list.
add radiusserver ipaddress=149.245.22.22 order=1
The following command adds the RADIUS server with the IP address
149.245.22.22. It specifies the server as the third RADIUS server to be
queried by the switch and has a UDP port of 1812.
add radiusserver ipaddress=149.245.22.22 order=3
port=1812
The following command adds a RADIUS server with an IP address of
149.245.22.22. It specifies the order as 2, the encryption key as tiger74,
and the UDP port as 1812.
add radiusserver ipaddress=149.245.22.22 order=2
secret=tiger74 port=1812