Allied Telesis AT-S62 - Manual (Page 219)

AT-S62 Command Line User’s Guide
219
SHOW LOG
Syntax
show log [full] [module=module] [reverse]
[severity=severity]
Parameters
full Specifies the amount of information displayed by
the log. Without this option, the log displays the
time, module, severity, and description for each
entry. With it, the log also displays the filename, line
number, and event ID.
module Displays events associated with a particular AT-S62
module. For a list of modules, refer to Table 1 on
page 220.
reverse Controls the order of the events in the log. Without
this option, the events are displayed oldest to
newest. With this option, the events are displayed
newest to oldest.
severity Displays events of a selected severity. Choices are I
for Informational, E for Error, W for Warning, D for
Debug, and ALL for All. The default is informational,
error, and warning. You can select more than one
severity at a time (for example, E,W).
Description
This command displays the entries stored in the event log.
The event log can display entries in two modes, referred to as normal
and full. In the normal mode, the log displays the time, module, severity,
and description for each entry. In the full mode, the log also displays the
filename, line number, and event ID. If you want to view the entries in
the full mode, use the FULL parameter. To view entries in the normal
mode, simply omit the parameter.