Allied Telesis AT-S62 - Manual (Page 160)

Chapter 8: Port Parameter Commands
160
speed Sets the speed and duplex mode of the port.
Settings for this parameter are:
autonegotiate The port Auto-Negotiates both
speed and duplex mode.This is the
default setting.
10mhalf 10 Mbps and half-duplex mode.
10mfull 10 Mbps and full-duplex mode.
10mhauto 10 Mbps and half-duplex mode with
Auto-Negotiation.
10mfauto 10 Mbps and full-duplex mode with
Auto-Negotiation.
100mhalf 100 Mbps and half-duplex mode.
100mfull 100 Mbps and full-duplex mode.
100mhauto 100 Mbps and half-duplex mode
with Auto-Negotiation.
100mfauto 100 Mbps and full-duplex mode
with Auto-Negotiation.
1000mfull 1000 Mbps and full-duplex mode.
1000mfauto 1000 Mbps and full-duplex mode
with Auto-Negotiation.
Note
The selections 10mfauto, 100mhauto, 100mfauto, and 1000mfauto
cause a port to Auto-Negotiate to a lower speed and/or to half
duplex mode if required by the end node.
mdimode Sets the wiring configuration of the port. This
parameter applies only to twisted pair ports. You
cannot change the MDI/MDIX setting when a port’s
speed is set to Auto-Negotiate. Possible values are:
mdi Sets the port’s configuration to MDI.
mdix Sets the port’s configuration to MDI-X.
auto Automatically sets the port’s wiring
configuration to either MDI or MDI-X,
depending on the end node connected
to the port. This is the default setting.
flowcontrol Specifies the flow control on the port. Flow control
applies only to ports operating in full duplex mode.
When flow control is activated, a port sends out a
PAUSE packet whenever it wants the end node to
stop sending packets. Possible values for this