Allied Telesis AT-S62 - Manual (Page 222)

Chapter 15: Event Log Commands
222
An example of the event log in full display mode is shown in
Figure 1.
Figure 1 Event Log Example
The columns in the log are described below:
❑ S (Severity) - The event’s severity. Refer to Table 2 on page 221.
❑ Date/Time - The date and time the event occurred.
❑ Event - The module within the AT-S62 software that generated
the event followed by a brief description of the event. For a list of
the AT-S62 modules, see Table 1 on page 220.
❑ Event ID - A unique number that identifies the event. (Displayed
only in the full display mode.)
❑ Filename and Line Number - The subpart of the AT-S62 module
and the line number that generated the event. (Displayed only in
the full display mode.)
Examples
The following command displays the informational, error, and warning
entries in the event log:
show log
This example displays the log in the full display mode, which adds more
information:
show log full
This example displays only those entries associated with the AT-S62
modules FILE and QOS:
show log module=file,qos
S Date Time EventID Source File:Line Number
Event
------------------------------------------------------------------
I 2/01/04 09:11:02 073001
garpmain.c:259
garp: GARP initialized
I 2/01/04 09:55:15 083001 portconfig.c:961
pcfg: PortConfig initialized
I 2/01/04 10:22:11 063001 vlanapp.c:444
vlan: VLAN initialization succeeded
I 2/01/04 12:24:12 093001 mirrorapp.c:158
pmirr: Mirror initialization succeeded
I 2/01/04 12:47:08 043016 macapp.c:1431
mac: Delete Dynamic MAC by Port[2] succeeded