Allied Telesis AT-S62 - Manual (Page 405)

AT-S62 Command Line User’s Guide
405
ADD MGMTACL
Syntax
add mgmtacl ipddress=ipaddress mask=string
protocol=tcp|udp|all interface=telnet|web|all
Parameters
ipaddress Specifies the IP address of a specific management
workstation or of a subnet.
mask Specifies the mask used by the switch to filter the IP
address. A binary “1” indicates the switch should filter
on the corresponding bit of the address, while a “0”
indicates that it should not. If, in the IPADDRESS
parameter, you specified the IP address of a specific
management workstation, the appropriate mask is
255.255.255.255. If you are filtering on a subnet, then
the mask would depend on the subnet address. For
example, for a Class C subnet address of 149.11.11.32,
the mask would be 255.255.255.224.
protocol Specifies the protocol of the management packets.
The options are:
tcp Transmission control protocol.
udp User datagram protocol.
all Both TCP and UDP packets.
Note
Since management packets from both Telnet and web browser
management sessions are TCP, you should specify either TCP or ALL.
Do not specify UDP.
interface Specifies the type of remote management allowed.
The options are:
telnet Telnet management
web Web management
all Both Telnet and web management