Allied Telesis AT-S62 - Manual (Page 337)

AT-S62 Command Line User’s Guide
337
SET PORTACCESS|PORTAUTH PORT ROLE=AUTHENTICATOR
Syntax
set portaccess|portauth port=port
type|role=authenticator|none
[control=auto|authorised|forceauthenticate|
unauthorised|forceunauthenticate]
[quietperiod=value] [txperiod=value]
[reauthperiod=value] [supptimeout=value]
[servertimeout|servtimeout=value] [maxreq=value]
[ctrldirboth=ingress|both]
Note
The PORTACCESS and PORTAUTH keywords are equivalent.
Parameters
port Specifies the port that you want to set to the
Authenticator role or whose Authenticator settings
you want to adjust. You can specify more than one
port at a time.
type Specifies the role of the port. The parameters are
role equivalent. The role can be one of the following:
authenticator Specifies the Authenticator
role.
none Disables port-based access
control on the port.
control Specifies the authenticator state. This parameter can
take the following values:
auto Sets the port state to 802.1X
port-based authentication.
The port begins in the
unauthorized state, allowing
only EAPOL frames to be
sent and received through
the port. The authentication
process begins when the
link state of the port
changes. The switch
requests the identity of the
client and begins relaying
authentication messages