Allied Telesis AT-S62 - Manual (Page 107)

AT-S62 Command Line User’s Guide
107
CREATE SNMPV3 GROUP
Syntax
create snmpv3 group username=username
[securitymodel=v1|v2c|v3] groupname=groupname
[storagetype=volatile|nonvolatile]
Parameter
username Specifies a user name configured in the SNMPv3 User
Table.
securitymodel Specifies the security model of the above user name.
The options are:
v1 Associates the Security Name, or User Name,
with the SNMPv1 protocol.
v2c Associates the Security Name, or User Name,
with the SNMPv2c protocol.
v3 Associates the Security Name, or User Name,
with the SNMPv3 protocol.
groupname Specifies a group name configured in the SNMPv3
Access Table with the access parameter. See CREATE
SNMPV3 ACCESS on page 102.
storagetype Specifies the storage type of this table entry. This is an
optional parameter. The options are:
volatile Does not allow you to save the table
entry to the configuration file on the
switch. This is the default.
nonvolatile Allows you to save the table entry to
the configuration file on the switch.
Description
This command creates an SNMPv3 SecurityToGroup Table entry.