Allied Telesis AT-S62 - Manual (Page 328)

Chapter 24: Port Security Commands
328
intrusionaction Specifies the action taken by the port in the event
port security is violated. This parameter applies only
to the Limited security mode. Intrusion actions are:
discard Discards invalid frames. This is the
default setting.
trap Discards invalid frames and sends a
SNMP trap.
disable Discards invalid frames, sends an SNMP
trap, and disables the port.
learn Specifies the maximum number of dynamic MAC
addresses a port on the switch can learn. This
parameter applies only to ports set to the Limited
security mode. The range is 1 to 255 addresses. The
default is 255.
participate Enables or disables the intrusion action on the port.
This option only applies to the Limited security mode
and only when a port’s intrusion action is set to trap or
disable. This option does not apply when intrusion
action is set to discard. Options are:
yes, on, true Enables the trap or disable intrusion
action. These values are equivalent.
no, off, false Disables the trap or disable intrusion
action. The port still discards invalid
ingress frames. This is the default. These
values are equivalent.
Description
This command sets and configures a port’s security mode. Only one
mode can be active on a port at a time.
Note
Refer to the AT-S62 Management Software User’s Guide for
explanations of the security levels and intrusion actions.
To view a port’s current security mode, use the command SHOW SWITCH
PORT SECURITYMODE on page 331.
The management software displays a confirmation prompt whenever
you perform this command. Responding with Y for yes completes your
command, while N for no cancels the command.