Allied Telesis AT-S62 - Manual (Page 330)

Chapter 24: Port Security Commands
330
SHOW SWITCH PORT INTRUSION
Syntax
show switch port=port intrusion
Parameters
port Specifies the port where you want to view the
number of intrusions that have occurred. You can
specify more than one port at a time.
Description
This command displays the number of times a port has detected an
intrusion violation. An intrusion violation varies depending on the
security mode:
❑ Limited Security Level - An intrusion is an ingress frame with a
source MAC address not already learned by a port after the port
had reached its maximum number of dynamic MAC addresses, or
that was not assigned to the port as a static address.
❑ Secured Security Level - An intrusion is an ingress frame with a
source MAC address that was not entered as a static address on
the port.
❑ Locked - An intrusion is an ingress frame with a source MAC
address that the port has not already learned or that was not
assigned as a static address.
Example
This command displays the number of intrusion violations detected on
ports 12 and 21:
show switch port=12,21 intrusion