Allied Telesis AT-S62 - Manual (Page 58)

Chapter 4: Basic Switch Commands
58
SHOW CONFIG
Syntax
show config [dynamic] [info]
Parameters
dynamic Displays the settings for all the switch and port
parameters in their equivalent command line
commands.
info Displays all switch settings.
Description
This command, when used without any parameter, displays two pieces
of information. The first is the “Boot configuration file.” This is the
configuration file the switch uses the next time it is reset or power
cycled. This is also the configuration file the switch uses to save your
configuration changes whenever you use the SAVE CONFIGURATION
command. To change the boot configuration file, refer to SET CONFIG on
page 199.
The second piece of information is the “Current Configuration.” This is
the boot configuration file the switch used the last time it was reset or
power cycled.
The DYNAMIC parameter displays the equivalent command line
commands for those switch parameters that have been changed from
their default settings.
The INFO parameter displays all the switch settings. It performs the same
function as all the other SHOW commands in one command.
Example
The following command displays the names of the current configuration
files:
show config
This command displays all the switch settings:
show config info