Allied Telesis AT-S62 - Manual (Page 314)

Chapter 23: GARP VLAN Registration Protocol Commands
314
ENABLE GARP
Syntax
enable garp=gvrp [gip]
Parameters
garp Specifies the GARP application you want to enable.
The only GARP application supported by AT-S62
management software is GVRP.
gip Enables GARP Information Propagation (GIP).
Note
The online help for this command contains an STP option. The
option is not supported.
Description
This command enables GVRP on the switch. Once activated, the switch
will learn dynamic GVRP VLANs and dynamic GVRP ports. The default
setting for GARP is disabled.
This command can also be used to enable GIP. GIP must be enabled for
GVRP to operate properly.
Examples
This commands enables GVRP on the switch:
enable garp=gvrp
This command enables GIP only:
enable garp=gvrp gip