Allied Telesis AT-S62 - Manual (Page 342)

Chapter 25: 802.1x Port-based Access Control Commands
342
startperiod Specifies the time period in seconds between
successive attempts by the supplicant to establish
contact with an authenticator when there is no
reply. The range is 1 to 60. The default is 30.
username Specifies the username for the switch port. The
name parameters are equivalent. The port sends the
name to the authentication server for verification
when the port logs on to the network. The
username can be from 1 to 64 alphanumeric
characters (A to Z, a to z, 1 to 9). Do not use spaces
or special characters, such as asterisks or
exclamation points. The username is case-
sensitive.
password Specifies the password for the switch port. The port
sends the password to the authentication server
for verification when the port logs on to the
network. The password can contain alphanumeric
characters (A to Z, a to z, 1 to 9). Do not use spaces
or special characters, such as asterisks or
exclamation points. The password is case-sensitive.
Description
This command sets ports to the Supplicant role and configures the
Supplicant role parameters. This command also disables port-based
access on a port.
Example
This command sets ports 4 to 6 to the Supplicant role:
set portaccess port=4-6 role=supplicant
The following command sets port 8 to the Supplicant role. It sets the
name to “switch22” and the password to “bluebird”:
set portaccess ports=8 role=supplicant
name=switch22 password=bluebird
The following command disables port-based access control on ports 12
and 15:
set portaccess port=12,15 role=none