Triton TritonNav - Manual (Page 73)

2004.06.28 CHAPTER 1: Using DelphNav™ (Survey Control Panel) 67
Using Delph Nav An Example of Survey Planning in DelphNav
Creating a Channel
The steps that are needed to create a channel are:
1. Generate two lines defining the edges or border of the channel.
2. Generate the transverse lines defining the channel cross section.
To create a channel before a survey plan has been made
1. Click these icons in sequence:
•
Start/Stop Survey Planning Editor
→
•
Create a new survey planning
→
•
Done
→
•
Create channel .
The system displays two dialog boxes open: the Survey Planning Setup (Figure 43, left
side) and the Channel design procedure (Figure 43, right side).
FIGURE 43. Survey planning setup with channel design dialog