HP StorageWorks XP Remote Web Console Software User Manual
Page 192
4.
Select Add JNLG to EXCTG from the pop-up menu.
The Add JNL Group window appears (
5.
If you do not want to register journal groups of the supervisor DKC, clear the check box of far left
of the DKCs (DKC-1 to DKC-4). If you want to register journal groups of the supervisor DKC,
select the check box of far left of the DKCs (DKC-1 to DKC-4).
6.
Select one from the DKCs (DKC-1 to DKC-4).
Notes:
• The word "DKC" represents a storage system.
• If you want to register journal groups of the supervisor DKC, please move on to step
11
on page 192 after this step.
7.
Enter the serial number of the storage system. If the serial number is already displayed and
unchangeable, you do not need to enter it.
8.
Enter the LDKC number. If the LDKC number is already displayed and unchangeable, you do
not need to enter it.
9.
Select the control ID.
10.
Specify the LDKC number and the LDEV number of the remote command device.
NOTE:
If the LDKC number and the LDEV number are already specified and unchangeable, you do not
need to specify them.
11.
From the JNLG list on the left, select one or more journal groups that you want to register.
12.
Select ->Add.
The selected journal groups move to the JNLG list on the right.
NOTE:
If the JNLG list on the right contains any journal group that you do not want to register, please select the
journal group from the list and then click <-Cancel.
13.
From Mirror ID, select a mirror ID.
NOTE:
If a mirror ID is already specified and unchangeable, you do not need to select it.
14.
If necessary, repeat steps 6–13 beginning on page
15.
Select Set to close the Add JNL Group window.
16.
See the Preview list to check the settings that you have made.
NOTE:
If you want to modify a setting, select and right-click the setting in the Preview list and then select
Modify. A window appears and allows you to modify the setting.
17.
Select Apply to register journal groups.
NOTE:
If an error occurs, the rightmost column of the Preview list displays the error code. To view detailed
information about the error, right-click the error code and then select Error Detail. An error message
appears and gives you detailed information about the error.
192
Using Extended Consistency Groups