HP StorageWorks XP Remote Web Console Software - Manual (Page 116)

Changing Options for Logical Paths and Storage Systems
The DKC Option window (see Figure 51 on page 116) allows you to set the logical path options and
storage system options. These options will apply to the local storage system and the corresponding
remote storage system.
To change logical path options and storage system options, follow the procedure below. Not only the
primary storage system administrator but also the secondary storage system administrator can perform
this operation:
1. Ensure that the XP Remote Web Console main window is in Modify mode.
For detailed information about how to do this, please refer to XP Remote Web Console User’s Guide.
2. Ensure that the DKC Operation window is displayed.
3. In Display, select DKC.
4. Select LDKC from the tree.
The list displays a list of remote storage systems.
5. From the list, select and right-click the desired remote storage system,
6. From the pop-up menu, select DKC Operation and Change DKC Option.
The DKC Option window appears (
Figure 51 on page 116).
7. On the DKC Option window, change the options as desired. For detailed information about the
options, refer to explanations below Figure 51 on page 116.
8. Select Set to close the DKC Option window.
9. See the Preview list to check the settings that you have made.
• If you want to modify a setting, select and right-click the setting from the Preview list and then
select Modify. A window appears and allows you to modify the setting.
• If you want to cancel a setting, select and right-click the setting in the Preview list and then
select Cancel.
10. Select Apply to apply the settings that you have made. If an error occurs, the rightmost column of
the Preview list displays the error code. To view detailed information about the error, right-click
the error code and then select Error Detail. An error message appears and gives you detailed
information about the error.
Figure 51 DKC Option Window
The DKC Option window displays the following:
• The Minimum Paths option specifies the minimum number of paths required for each remote
storage system connected to the local storage system (default = 1).
NOTE:
You cannot change the Minimum Paths for the current version.
• The I/O missing interrupt handler (RIO MIH) Time setting specifies the RIO MIH timer value,
which is the wait time until data transfer from the local storage system to the remote storage
116 Configuring Disk Storage Systems and Logical Paths