HP StorageWorks XP Remote Web Console Software - Manual (Page 118)

Figure 52 Add Path Window
The Add Path window displays the following:
• Port: allows you to select an initiator port on the local storage system. When specifying a port,
you can use the keyboard to enter the port number. When you enter the port number, you can
abbreviate the port number into two characters. For example, you can enter 1A instead of CL1-A.
You can use uppercase and lowercase letters.
• Pair-Port: allows you to select an RCU target port on the remote storage system.
• Set: closes the Add Path window and adds the settings to the Preview list.
• Cancel: cancels the settings.
Deleting Logical Paths
Before deleting logical path(s), make sure that the remaining number of logical paths will be greater than
the minimum number of paths setting. The delete path operation will fail if the number of remaining paths
is equal to or less than the minimum number of paths.
To delete logical path(s), follow the procedure below. Not only the primary storage system administrator
but also the secondary storage system administrator can perform this operation:
1. Ensure that the XP Remote Web Console main window is in Modify mode.
For detailed information about how to do this, please refer to XP Remote Web Console User’s Guide.
2. Ensure that the DKC Operation window is displayed.
3. In Display, select DKC.
4. Do either of the following:
• In the tree, select a remote storage system.
• In the list, select and right-click a remote storage system and then select Edit Path(s) from the
pop-up menu. The list displays information about logical paths.
5. In the list, select the logical path(s) that you want to delete.
6. Right-click the list and then select Delete Path from the pop-up menu.
A confirmation message appears.
7. Select OK to close the message.
8. In the DKC Operation window, locate the upper-right list and the Preview list and then check
the settings that you have made.
• The right-most column of the upper-right list displays the word "Delete" to indicate logical
path(s) to be deleted.
• The Preview list displays logical path(s) to be deleted.
118 Configuring Disk Storage Systems and Logical Paths