HP StorageWorks XP Remote Web Console Software - Manual (Page 84)

3. Registering hosts in host groups
4. Associating host groups or iSCSI targets to logical volumes
If you are configuring an iSCSI environment, complete the following major steps:
1. Creating host groups
2. Registering hosts in host groups
3. Associating host groups or iSCSI targets to logical volumes
If you are configuring a NAS environment, complete the procedure described in Associating host
groups or iSCSI targets to logical volumes .
Creating host groups
NOTE:
If you are configuring a NAS environment, you do not need to follow the procedures described in
this section. For instructions on defining LU paths in NAS environments, see
Associating host groups
or iSCSI targets to logical volumes .
Creating host groups (when configuring Fibre Channel environments)
You can connect multiple server hosts of different platforms to one port on the array. When configuring
the system, you must group server hosts connected to the array by host groups. For example, if HP-UX
and Windows hosts are connected to a port, you must create one host group for HP-UX hosts and
another host group for Windows hosts. Next, you must register HP-UX hosts to the corresponding host
group and register Windows hosts to the other host group.
The following procedure describes how to create host groups. The procedure for registering hosts to
a host group is described in
Registering hosts in host groups .
1. Start XP LUN Configuration and Security Manager Software. The XP LUN Configuration and
Security Manager Software pane (
Figure 14 ) appears.
XP LUN Configuration and Security Manager Software operations 84