Registering hosts in host groups, Add new iscsi target pane (option selected) – HP StorageWorks XP Remote Web Console Software User Manual
Page 92

6.
If necessary, click Option, and select host mode options. For more information about host mode
options, see
.
Figure 38 Add New iSCSI Target pane (Option selected)
.
NOTE:
After you click Option, the pane expands to display a list of host mode options. The No.
column indicates option numbers. Select the check box for the option you want to specify.
7.
Click OK. If a message appears, click OK. The iSCSI target name and host mode appear in blue.
8.
Click Apply. A confirmation message appears.
9.
Click OK. Settings are applied to the array.
Registering hosts in host groups
NOTE:
If you are configuring a NAS environment, you do not need to follow the procedures described in
this section. For instructions, see
Associating host groups or iSCSI targets to logical volumes
To set LU paths, you must register hosts in host groups. For example, if HP-UX and Windows hosts
are connected to a port, you must register the HP-UX and Windows hosts separately in two different
host groups.
If you are configuring a Fibre Channel environment, follow the instructions in
groups (when configuring Fibre Channel environments)
. If you are configuring an iSCSI environment,
follow the instructions in
Registering hosts in iSCSI targets (when configuring iSCSI environments)
.
Registering hosts in host groups (when configuring Fibre Channel environments)
When registering a host, you must specify the host bus adapter's WWN. If you are unsure of the host
bus adapter's WWN, see
Finding an open-system host's World Wide Name (WWN)
When registering a host, you can assign a nickname to the host bus adapter. If you assign a nickname,
you can easily identify each host bus adapter in the XP LUN Configuration and Security Manager
XP LUN Configuration and Security Manager Software operations
92